Datavideo TP-600 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Datavideo TP-600. Datavideo TP-600 16 pages. Eng prompter

PROMPTER KIT FOR ENG CAMERAS

SHAN-TM700 tripod adapter plate shown

without riser block

10. Secure the ENG tripod adapter plate (not

supplied) and riser block item N (if required) to

the prompter rail item A using two of the riser

screws provided, items L or M. These screws

go through the long slot on the riser block and

prompter rail and into the base of the tripod

adapter plate.

Two screw sets are provided, the long set (Item

M 31mm long) is for when using the riser block.

The short set (Item L 16mm long) when just

using the camera plate on its own.

Items Q and R are provided in case the tripod

adapter plate and riser block need to be

positioned over the tripod head.

11. You can now mount the ENG camera to the

tripod adapter plate. Take care to protect the

camera lens and the 60/40 mirror glass. If

necessary slide everything further along the

prompter frame.

The tip of the lens should be about 1 to 2 cm

away from the centre of the 60/40 Mirror Glass.

It may be a good idea to remove the lens

sun hood if this is possible.

12. Fit the Snood / Hood support wire, item K.. This

stops the cloth Snood / Hood from dipping in

front of the camera lens. There are two sets of

holes in the glass frame for this Snood / Hood

support wire.

13. Fit the cloth Snood / Hood, item I, around the

lens and to the Glass Frame edges, item G. The

Velcro strips marry the Snood/Hood to the Glass

Frame.

TP-600