Agri-Fab 45-0358 Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Agri-Fab 45-0358. Agri-Fab 45-0358 8 pages. Box scraper attachment
Également pour Agri-Fab 45-0358 : Manuel du propriétaire (8 pages)

Imprimer la page

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2) 3/4" Wrenches

(1) 9/16" Wrench

(1) 1-1/2" Wrench or 14" Adjustable Wrench

(1) Pliers

CAUTION: USE CARE IN HANDLING AND

ASSEMBLY OF BOX SCRAPER. WEAR

GLOVES FOR EXTRA PROTECTION

AGAINST CUTS.

Remove all loose parts and the hardware package

from the shipping carton. Then lay out and identify

each part and the common hardware as shown on

pages 2 and 3. Be sure the carton is empty before it is

discarded.

1. Lower the grader blade inside the box scraper

attachment. Then align the holes at the ends of

the box scraper with the holes in the grader blade.

Attach the box scraper attachment to the grader

blade using two 3/8" x 1" hex bolts and two 3/8"

Nylock hex nuts at each end of the box scraper.

Do not tighten yet. See figure 1.

GRADER BLADE

3/8" x 1"

HEX BOLT

FIGURE 1

BOX SCRAPER

ATTACHMENT

3/8" NYLOCK

HEX NUT

2. Connect the brace located on top of the box scraper

to the mast assembly using a 1/2" x 4" hex bolt and

1/2" Nylock hex nut. Tighten all nuts now. See

figure 2.

MAST

ASSEMBLY

BRACE

1/2" NYLOCK

HEX NUT

FIGURE 2

3. Attach four scarifier teeth to the box scraper using

a clevis pin and a haircotter pin for each tooth. Put

the tip of each scarifier tooth toward the front of

the box scraper. See figure 3.

For assembly purposes, put the clevis pins in the

bottom hole of each scarifier tooth.

HAIRCOTTER PIN

SCARIFIER

TOOTH

(TIP TOWARD

FRONT)

FIGURE 3

1/2" x 4"

HEX BOLT

CLEVIS PIN