Agri-Fab 45-0358 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Agri-Fab 45-0358에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-0358 8 페이지. Box scraper attachment
Agri-Fab 45-0358에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)
페이지 인쇄ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2) 3/4" Wrenches
(1) 9/16" Wrench
(1) 1-1/2" Wrench or 14" Adjustable Wrench
(1) Pliers
CAUTION: USE CARE IN HANDLING AND
ASSEMBLY OF BOX SCRAPER. WEAR
GLOVES FOR EXTRA PROTECTION
AGAINST CUTS.
Remove all loose parts and the hardware package
from the shipping carton. Then lay out and identify
each part and the common hardware as shown on
pages 2 and 3. Be sure the carton is empty before it is
discarded.
1. Lower the grader blade inside the box scraper
attachment. Then align the holes at the ends of
the box scraper with the holes in the grader blade.
Attach the box scraper attachment to the grader
blade using two 3/8" x 1" hex bolts and two 3/8"
Nylock hex nuts at each end of the box scraper.
Do not tighten yet. See figure 1.
GRADER BLADE
3/8" x 1"
HEX BOLT
FIGURE 1
BOX SCRAPER
ATTACHMENT
3/8" NYLOCK
HEX NUT
2. Connect the brace located on top of the box scraper
to the mast assembly using a 1/2" x 4" hex bolt and
1/2" Nylock hex nut. Tighten all nuts now. See
figure 2.
MAST
ASSEMBLY
BRACE
1/2" NYLOCK
HEX NUT
FIGURE 2
3. Attach four scarifier teeth to the box scraper using
a clevis pin and a haircotter pin for each tooth. Put
the tip of each scarifier tooth toward the front of
the box scraper. See figure 3.
For assembly purposes, put the clevis pins in the
bottom hole of each scarifier tooth.
HAIRCOTTER PIN
SCARIFIER
TOOTH
(TIP TOWARD
FRONT)
FIGURE 3
4
1/2" x 4"
HEX BOLT
CLEVIS PIN