AUSTRAMAC FLASHCUT 1400 RM Manuel de l'opérateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} AUSTRAMAC FLASHCUT 1400 RM. AUSTRAMAC FLASHCUT 1400 RM 14 pages. Diamond rock saw
Imprimer la page15. Removal of guard is not recommended.
16. Operator to check all equipment as listed in pre start check (above)
after completing a test cut.
17. Equipment to be checked every hour for damage or lose bolts.
18. Operator to only use approved AUSTRAMAC blades designed for
material being cut and the correct size for the rock saw (see
identification label).
19. Operator to observe blade at all times while cutting, if circular
scratches are observed on boundary wall, or blade begins to wobble
cease cutting immediately and check bolts.
20. Never use blade that is out of tension.
21. Ensure that excavator is operated as per manufactures instructions
and appropriate warning lights and signals are operating.
22. Once the cut is complete, slowly raise the saw so that only
approximately 100mm of blade in still in the cut. Turn off oil and
allow blade to stop in cut. Remove saw from cut and place on stand.
•
Clean saw
At completion of work operator to wash down rock saw to assist with
inspection and clean parts.
•
Post use inspection
1. Operator to inspect the saw at completion of cutting and at regular
intervals.
2. Operator to check connection to excavator secure, hoses are
connected appropriately, head bracket is tight, the guard is in the
correct position and secure, no more than two segments in a row
missing and no more than a total of four missing on the blade,
adequate cutting time left on blade (minimum 3mm), bolts to blade
are tightened to
bearings are tight.
3. Operator to wear leather gloves and never place hand over hydraulic
leaks.
120Nm and flange bolts to140Nm
, all components and
10