- ページ 10

ソウ AUSTRAMAC FLASHCUT 1400 RMのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AUSTRAMAC FLASHCUT 1400 RM 14 ページ。 Diamond rock saw

15. Removal of guard is not recommended.

16. Operator to check all equipment as listed in pre start check (above)

after completing a test cut.

17. Equipment to be checked every hour for damage or lose bolts.

18. Operator to only use approved AUSTRAMAC blades designed for

material being cut and the correct size for the rock saw (see

identification label).

19. Operator to observe blade at all times while cutting, if circular

scratches are observed on boundary wall, or blade begins to wobble

cease cutting immediately and check bolts.

20. Never use blade that is out of tension.

21. Ensure that excavator is operated as per manufactures instructions

and appropriate warning lights and signals are operating.

22. Once the cut is complete, slowly raise the saw so that only

approximately 100mm of blade in still in the cut. Turn off oil and

allow blade to stop in cut. Remove saw from cut and place on stand.

•

Clean saw

At completion of work operator to wash down rock saw to assist with

inspection and clean parts.

•

1. Operator to inspect the saw at completion of cutting and at regular

intervals.

2. Operator to check connection to excavator secure, hoses are

connected appropriately, head bracket is tight, the guard is in the

correct position and secure, no more than two segments in a row

missing and no more than a total of four missing on the blade,

adequate cutting time left on blade (minimum 3mm), bolts to blade

are tightened to

bearings are tight.

3. Operator to wear leather gloves and never place hand over hydraulic

leaks.

120Nm and flange bolts to140Nm

, all components and