Benedini TBS Mini Manuel de données techniques - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de données techniques pour {nom_de_la_catégorie} Benedini TBS Mini. Benedini TBS Mini 11 pages. Digital multifunctional rc-soundunit
Également pour Benedini TBS Mini : Manuel (11 pages), Manuel (11 pages)
Imprimer la page
3.2. Direct Sound Selection
For this control mode you need a proportional channel equipped with a 3 position switch. It is
possible for you to replace a rarely used Pot input on the TX with another 3pos switch for sound
unit use. There are two Direct Sound Selection modes you can use (see below).
The output of the RX channel you assign this input to needs to move from -100, to 0, to +100 for
the three positions.
3.2.1. Direct Sound Selection using the Prop2 input
You do not need to 'teach' the Sound unit anything for this mode. The 3pos switch RX channel
must be connected to Prop2 input of the TBS Mini Prop2 input. The mode set for Prop2 in the TBS
Mini must be set to "Function ½" by the TBS Flash software. The two switch positions will play:
1) The engine Start or Shutdown sound (toggles) and 2) The first sound file in the Additional
Sounds list.
These settings are already done if this control mode was ordered with Direct Sound Selection.
The two triggered sounds are set in the TBS Mini flash memory (as set by the TBS Flash) and
others cannot be selected. They can be changed by reprogramming the TBS Mini using the optional
USB programming cable with a PC.
3.2.2. Direct Sound Selection using the Prop3 input
The advantage of this Direct Sound Selection mode is that you can choose/program the desired
Additional Sound by 'teaching' the TBS Mini Sound unit which one you want to use.
The 3pos switch RX channel must be connected to the Prop3 input of the TBS Mini. The mode set
for Prop2 in the TBS Mini must be set to "12 position encoder by using the TBS Flash software.
The two switch positions will play: 1) The engine Start or Shutdown sound (toggles) and 2) The
Sound File you 'teach it' from the Additional Sounds list in the TBS Mini.
1) Power on the transmitter and receiver. The sound unit LED blinks fast = normal mode.
Bring all joysticks to neutral position and the throttle stick to minimum.
2) Press the LEARN button until one beep occurs = the LED is continuously lit.
At this step all neutral / idle positions are stored.
3) Move the throttle stick to your desired acceleration point (the position where you want the
engine idle sound to change to the moving sound) and flick the 3way switch UP.
A short sequence of the acceleration sound file is played.
4) Move throttle stick to full throttle and flick the 3way switch UP again.
A short sequence of the full speed sound file is played.
5) Flick the switch UP.
The Engine start/stop Sound File is stored to this direction of the switch.
6) If you want to skip the next sound file in the list, flick the switch UP again.
A section of that sound is played but NOT stored to this direction of the switch, because it is
already occupied by the above Engine Start/Stop function.
7) Repeat step 6 to skip any further sound you do not want to select.
8) At your desired sound is next then flick the switch DOWN.
9) Power the sound unit off and on.
Now you can activate the two selected sounds directly by the two non-centre switch positions.
You may need to run this teaching sequence several times because you probably don't know which
sound appears next in the sound list until you have tried it.
TBS Mini
www.benedini.de
Page 7 of 11