Dymo DYMO S150 Digital Shipping Scale and 4XL Label Printer Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dymo DYMO S150 Digital Shipping Scale and 4XL Label Printer. Dymo DYMO S150 Digital Shipping Scale and 4XL Label Printer 8 pages. Digital shipping scale

Imprimer la page

Technical Specifications

Model

Capacity

Resolution

Units

Auto Shut Off

Operating Temperature

Power

For information about our other scale products, visit www.dymo.com.

Troubleshooting

Problem/Error Message

No display

is displayed

Negative number is displayed

is displayed

0.0

Display reads

with an item on the

platform

S150 is displayed

If you need further assistance, contact Technical Support at (877) 724-8324. You can also

obtain support at www.dymo.com.

S150

150 pounds (68 kg)

0.2 lb. (0.1 kg)

lb. (kg)

After two minutes of inactivity

40° - 104° F (4.5° - 40° C)

110 V AC adapter or 9-volt

alkaline battery

Solution

Ensure the scale is plugged in, or replace the battery.

Replace the 9-volt battery.

A tare value is displayed as a negative number when the items

are removed from the scale. Press ZERO/HOLD to reset the

scale to zero.

The item on the scale platform exceeds the maximum capacity

of the scale. Remove the item immediately to prevent damage

to the scale.

This can happen because:

• The ZERO/HOLD button was pressed while an item was on

the scale.

• Power to the scale was disconnected or turned off and then

on again with an item on the scale.

In both of these cases, remove the item from the platform and

press the ZERO/HOLD button to return the display to 0.0.

With the scale off, do one of the following:

• Make sure nothing is on the scale platform, make sure the

scale is on a flat surface, and then turn the scale on.

• Rotate the power adapter in the power outlet, plug the

power adapter into a different outlet, or switch to battery

power and then turn the scale on.

• Unplug the coiled cable from the scale display, plug the cable

back into the scale display, making sure the connector clicks

into place, and then turn the scale on.