Hi-Force TWE Series Manuel d'utilisation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Hi-Force TWE Series. Hi-Force TWE Series 20 pages. Electric torque wrench
Imprimer la page
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
The two diode lights flash red alternately. The
error is documented.
Remedy: Unplug the tool and plug in again. If
the error is still present, send device to Hi-Force
Limited.
3.5.2 Error in the temperature sensor
If there is any error in temperature
measurement, the message Sys02 flashes in the
display for 3 seconds.
Bolting process is interrupted.
Additionally, an acoustic warning signal is
emitted.
The two diode lights flash red alternately. The
error is documented.
Remedy: Unplug the tool and plug in again. If
the error is still present, send device to Hi-Force
Limited.
3.5.3 Error motor overcurrent
If there is any error in motor over-current, the
message Sys03 flashes in the display for 3
seconds.
Bolting process is interrupted.
Additionally, an acoustic warning signal is
emitted.
The two diode lights flash red alternately. The
error is documented.
Remedy: Unplug the tool and plug in again. If
the error is still present, send device to Hi-Force
Limited.
Cause: Blockage of motor in clockwise rotation,
or short circuit in the coil.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 15 of 20
TDS:-
1399
Date: 25/03/14