GREAT PLAINS 1006NT Manuel d'instructions - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} GREAT PLAINS 1006NT. GREAT PLAINS 1006NT 6 pages. End wheel no-till
Imprimer la page
3.) Check the seed cups for any foreign objects. Loosen wing nut on seed rate handle
and open to 100% on the brass plate. Move handle back until the edge of the flute
is flush with the seam in the center of the cup (this is 50% open). A 7/8" block can
also be used to measure the 50% open measurement. If brass plate does not read
50 on the seed rate handle, loosen the screws holding the brass plate and adjust
plate to 50%. If an individual cup is not consistent, loosen the bolts holding the
cup to the bottom of the seed box and adjust seed cup housing left or right as
needed.
4.) Each feed cup is equipped with a four-position adjustment handle.
A. The highest position is for wheat and other small grains.
B. The second is for soybeans and other large grains.
C. The third is used if the seed is cracking in the second position.
D. The bottom position is for clean out of the seed cup and will drain any
grain left in the seed box.
DO NOT OPEN the seed cup handle to the bottom position with seed in the box
unless complete clean out is desired. Changing this handle will not change the
seeding rate.
NOTE: When storing the drill, it is best to place the handle in the bottom position
with brass gauge reading "0" to help prevent rodent damage.
Cup
Seam = 50%