GREAT PLAINS 1006NT Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt rolniczy GREAT PLAINS 1006NT. GREAT PLAINS 1006NT 6 stron. End wheel no-till

3.) Check the seed cups for any foreign objects. Loosen wing nut on seed rate handle

and open to 100% on the brass plate. Move handle back until the edge of the flute

is flush with the seam in the center of the cup (this is 50% open). A 7/8" block can

also be used to measure the 50% open measurement. If brass plate does not read

50 on the seed rate handle, loosen the screws holding the brass plate and adjust

plate to 50%. If an individual cup is not consistent, loosen the bolts holding the

cup to the bottom of the seed box and adjust seed cup housing left or right as

needed.

4.) Each feed cup is equipped with a four-position adjustment handle.

A. The highest position is for wheat and other small grains.

B. The second is for soybeans and other large grains.

C. The third is used if the seed is cracking in the second position.

D. The bottom position is for clean out of the seed cup and will drain any

grain left in the seed box.

DO NOT OPEN the seed cup handle to the bottom position with seed in the box

unless complete clean out is desired. Changing this handle will not change the

seeding rate.

NOTE: When storing the drill, it is best to place the handle in the bottom position

with brass gauge reading "0" to help prevent rodent damage.

Cup

Seam = 50%