GREAT PLAINS 1006NT Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt rolniczy GREAT PLAINS 1006NT. GREAT PLAINS 1006NT 6 stron. End wheel no-till

When transporting the drill, transport locks should always be used. This will prevent

damage to the drill and possible personal injury should hydraulic failure occur.

Always disengage the lockout hub before transporting the drill.

ADJUSTMENT BEFORE GOING TO THE FIELD

1.) After hooking the drill to the tractor and attaching hydraulic hoses, raise the drill

up to maximum height and hold the hydraulic lever in the detent for 30 seconds, to

allow the cylinders to rephase. This procedure will remove any air in the system

allowing the drill to raise and lower evenly. The rephasing procedure should be

repeated several times a day to ensure that the drill continues to lift evenly.

Remove the transport locks.

2.) Lower the drill to the ground and pull ahead at field speed and inspect the coulter

depth. Once set, visually check to see if the drill box lid and tongue are parallel to

the ground, if not, raise or lower the draw bar clevis until the drill lid is level when

drilling.

TRANSPORTING

Lock-Out Hub