GREAT PLAINS 1006NT Instructions Manual - Page 2

Browse online or download pdf Instructions Manual for Farm Equipment GREAT PLAINS 1006NT. GREAT PLAINS 1006NT 6 pages. End wheel no-till

Print Page
GREAT PLAINS 1006NT Instructions Manual
When transporting the drill, transport locks should always be used. This will prevent
damage to the drill and possible personal injury should hydraulic failure occur.
Always disengage the lockout hub before transporting the drill.
ADJUSTMENT BEFORE GOING TO THE FIELD
1.) After hooking the drill to the tractor and attaching hydraulic hoses, raise the drill
up to maximum height and hold the hydraulic lever in the detent for 30 seconds, to
allow the cylinders to rephase. This procedure will remove any air in the system
allowing the drill to raise and lower evenly. The rephasing procedure should be
repeated several times a day to ensure that the drill continues to lift evenly.
Remove the transport locks.
2.) Lower the drill to the ground and pull ahead at field speed and inspect the coulter
depth. Once set, visually check to see if the drill box lid and tongue are parallel to
the ground, if not, raise or lower the draw bar clevis until the drill lid is level when
drilling.
TRANSPORTING
Lock-Out Hub