Agriframes 40136 Instructions de montage - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Agriframes 40136. Agriframes 40136 4 pages. 6ft classic extra monet arch
Imprimer la page
Parts List
A90116
A44017
A44018
A40012
A30005
A42007
Assembly Instructions
1.
Preparation
1.1. Take the four uprights and tap an end plug into the standard end of each.
1.2. Place two screws in each T joint as shown, but only tighten the screws enough to
hold them in. Make sure the screw points do not protrude into the inside of the joints
as they will scratch the coating when they are attached to the tubes. Note that the
third screw hole in the joints will be used during final assembly.
1.3. Take the eight 22½" spacers. Push T joints onto both ends of all of them. Lay each
assembly flat to ensure the joints are parallel as shown below then measure the
exposed tube and ensure that it is 18½" long. If the measurement is greater than this
you will need to use a rubber mallet to knock the joints home.
2.
Assembling the roof section
2.1. Take the two Monet curves with plain ends, the two
Monet curves with one reduced end and two of the
22½" spacer bar assemblies. Refer to the diagram.
Slide a spacer onto the horizontal section of the two
Monet curves with a reduced end, connecting them
together so that they are parallel. Repeat for the plain
ended curves.
2.2. Refer to the diagram below. Take two 1" moisture
seals and two of the 22½" spacers. Slide a moisture seal onto the two reduced tube ends and connect
the two roof halves together. Ensure that the joins are covered by the moisture seals. Slide a second
spacer assembly onto each side of the roof section. Position the spacers according to the measurements
in the diagram at the end of the instructions.
2.3. Measure the diagonals of the roof section to ensure it is square and adjust if necessary.
Code
Quantity
1
Assembly kit (see check list)
2
Monet curve (plain ends)
2
Monet curve (reduced one end)
4
8
1
Quantity
Optional Component
2
Lattice panels 5 cells high x 4 cells wide
2
Lattice panels 4 cells high x 4 cells wide
24
18½"
Component
84" uprights
22 ½" spacer bars
Holemaker
Lattice ties