Agriframes 40136 Instrukcja montażu - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Meble zewnętrzne Agriframes 40136. Agriframes 40136 4 stron. 6ft classic extra monet arch

Drukuj stronę

Parts List

A90116

A44017

A44018

A40012

A30005

A42007

Assembly Instructions

Preparation

1.1. Take the four uprights and tap an end plug into the standard end of each.

1.2. Place two screws in each T joint as shown, but only tighten the screws enough to

hold them in. Make sure the screw points do not protrude into the inside of the joints

as they will scratch the coating when they are attached to the tubes. Note that the

third screw hole in the joints will be used during final assembly.

1.3. Take the eight 22½" spacers. Push T joints onto both ends of all of them. Lay each

assembly flat to ensure the joints are parallel as shown below then measure the

exposed tube and ensure that it is 18½" long. If the measurement is greater than this

you will need to use a rubber mallet to knock the joints home.

Assembling the roof section

2.1. Take the two Monet curves with plain ends, the two

Monet curves with one reduced end and two of the

22½" spacer bar assemblies. Refer to the diagram.

Slide a spacer onto the horizontal section of the two

Monet curves with a reduced end, connecting them

together so that they are parallel. Repeat for the plain

ended curves.

2.2. Refer to the diagram below. Take two 1" moisture

seals and two of the 22½" spacers. Slide a moisture seal onto the two reduced tube ends and connect

the two roof halves together. Ensure that the joins are covered by the moisture seals. Slide a second

spacer assembly onto each side of the roof section. Position the spacers according to the measurements

in the diagram at the end of the instructions.

2.3. Measure the diagonals of the roof section to ensure it is square and adjust if necessary.

Code

Quantity

Assembly kit (see check list)

Monet curve (plain ends)

Monet curve (reduced one end)

Quantity

Optional Component

Lattice panels 5 cells high x 4 cells wide

Lattice panels 4 cells high x 4 cells wide

18½"

Component

84" uprights

22 ½" spacer bars

Holemaker

Lattice ties