Aircraft PSCRUBWHT Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aircraft PSCRUBWHT. Aircraft PSCRUBWHT 12 pages.

Using your

1. Select an attachment. To use one of the 3 brush heads (Round, Flat

or Pointed), insert the rotating triangular shaft at the tip of the

POWERSCRUB into the corresponding opening in the centre of the

Brush head, and twist clockwise. To remove, simply twist in an

anticlockwise direction and detach.

2. To use the grey microfibre Pad or the sponge Pad, simply attached to

the pad holder using Velcro, and attach the Pad holder to the

POWERSCRUB as above. Please ensure that the Pad is placed

centrally on the Pad holder.

3. You may choose to use your POWERSCRUB with or without the

handle extension installed. To install, simply click into place. To

remove, press the Handle release button, and pull to detach.

4. You may also choose to moisten surfaces using a spray bottle

containing water or cleaning solution, before going over with your

POWERSCRUB.

5. Adjust the hinge to your preferred angle.

6. Press the Start/Stop button. The LED light on the handle will illuminate

green and the Brush head/Pad will start to rotate at 180rpm. Press

again to switch to high-speed mode (250rpm) – the Speed Indicator

light will now turn red. To turn off, press the Start/Stop button once

again. You may also hold down the button for 3 seconds when in low

speed mode to switch off.

7. You may submerge the rotation shaft (the section below the hinge) of

your POWERSCRUB in water for short periods. Do not allow the

section above the hinge to become submerged in water.

POWERSCRUB