AffloVest 8052 Mode d'emploi et manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Mode d'emploi et manuel du propriétaire pour {nom_de_la_catégorie} AffloVest 8052. AffloVest 8052 15 pages. With mobile mechanical oscillation therapy

Imprimer la page

STEP 1 – UNPACKING THE AFFLOVEST

Carefully unpack the AffloVest and its accessories.

You must verify that the battery is fully charged before using the vest.

STEP 2 - CHECKING BATTERY LEVEL AND CHARGING BATTERY

IMPORTANT

Use only the supplied rechargeable battery and the supplied power supply to ensure

safe and reliable operation of the AffloVest.

The battery must be fully charged before using the AffloVest for the first time.

To check the battery level, depress the fuel gauge push-button to activate the fuel

gauge LED's.

The battery LED's will light up to indicate the battery level.

1 LED blinking

2 LED's lit

(0 - 19%)

(20 - 39%)

To charge the battery, connect the power supply to a wall outlet and plug the power

supply into the battery port as shown. The power supply LED will turn on when

connected to the wall outlet.

Battery level push button

3 LED's lit

4 LED's lit

5 LED's lit

(40 - 59%)

(60 - 79%)

(80 - 100%)

Power Supply LED lit

Next, plug the power supply plug into the AffloVest battery. There is a small opening

at the bottom of the battery pouch.

Power supply connected to battery

IMPORTANT

• When the power supply is plugged into the battery, pay close attention not to

place any strain onto the power supply cord. Rough handling of the vest and

power supply while plugged into the battery could cause damage to the battery.

• When the battery is charging, the LED's will become lit with one (1) LED blinking.

Note, this may take 5 – 10 seconds for the LED's to light after plugging in the

power supply.

• It is recommended to allow the battery fully charge for at least three (3) hours and

until all LED's are solidly lit. At the completion of charging, disconnect the power

supply from the battery. It is recommended that the power supply be unplugged

from the wall outlet and stored until next use.

• The battery gauge LED's will remain lit for approximately one (1) minute after

removing the power supply.