GREAT PLANES ElectroStik ARF Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES ElectroStik ARF. GREAT PLANES ElectroStik ARF 20 pages.
Imprimer la page
❏
6. Bend the pushrods 90 degrees at the marks and cut
the excess wire 1/4" [6mm] beyond the bends. Install the 90°
bend in the pushrods into the outer holes of the servo arms.
Secure them with two nylon FasLinks.
Out-runner Motor, Battery, & Radio Installation
❏
1. Remove the battery door for the following steps. This
is done by lifting the front of the door as shown. The battery
door is held in place by four small but powerful magnets.
❏
2. Install the brushless motor onto the aluminum motor
mount (included with the motor) using four 3 x 8mm machine
screws (included with the motor) and threadlocking compound.
❏
3. Attach the brushless motor to the fi rewall using four
4-40 x 5/8" [15.9mm] hex head screws, four #4 fl at washers and
threadlocking compound. If you haven't done so already, install
the prop adapter using the hardware included with the motor.
❏
4. Push the motor wires through the cooling hole cutout
on the fi rewall as shown to prevent them from contacting the
rotating motor case.
❏
5. Use hook and loop material or double-sided tape (not
included) to secure the ESC to the side of the fuselage as
shown. You may connect the motor wires at this time but leave
them accessible in case you need to reverse the direction of
the motor. Feed the receiver and battery leads on the ESC
through the second former. Connect the receiver lead of the
ESC to the receiver.
11