GREAT PLANES ElectroStik ARF Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES ElectroStik ARF. GREAT PLANES ElectroStik ARF 20 stron.

❏

6. Bend the pushrods 90 degrees at the marks and cut

the excess wire 1/4" [6mm] beyond the bends. Install the 90°

bend in the pushrods into the outer holes of the servo arms.

Secure them with two nylon FasLinks.

Out-runner Motor, Battery, & Radio Installation

❏

1. Remove the battery door for the following steps. This

is done by lifting the front of the door as shown. The battery

door is held in place by four small but powerful magnets.

❏

2. Install the brushless motor onto the aluminum motor

mount (included with the motor) using four 3 x 8mm machine

screws (included with the motor) and threadlocking compound.

❏

3. Attach the brushless motor to the ﬁ rewall using four

4-40 x 5/8" [15.9mm] hex head screws, four #4 ﬂ at washers and

threadlocking compound. If you haven't done so already, install

the prop adapter using the hardware included with the motor.

❏

4. Push the motor wires through the cooling hole cutout

on the ﬁ rewall as shown to prevent them from contacting the

rotating motor case.

❏

5. Use hook and loop material or double-sided tape (not

included) to secure the ESC to the side of the fuselage as

shown. You may connect the motor wires at this time but leave

them accessible in case you need to reverse the direction of

the motor. Feed the receiver and battery leads on the ESC

through the second former. Connect the receiver lead of the

ESC to the receiver.