GREAT PLANES ElectroStik ARF Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES ElectroStik ARF. GREAT PLANES ElectroStik ARF 20 stron.

❏

3. Slide a 3/32" [2.4mm] wheel collar between the nylon

tail gear bearing and the tail wheel bracket as shown. Thread

the steering wire between the horizontal stabilizer and the

elevator as shown and insert the tail wheel assembly through

the tail wheel bracket. Secure it by inserting a 4-40 set screw

and tightening it with a .050 [1.2mm] hex driver. Be sure to

use threadlocking cement on the set screw.

❏

4. Slide the steering wire into the rudder post as shown.

❏

5. Slide the tail wheel in place on the tail wheel axle. Slide

the nylon retainer in place onto the axle and secure it by

pressing it into place as shown.

❏

6. Put the landing gear in place as shown. Using a 3/32"

[2.4mm] hex driver, secure the brace with a 4-40 x 1/2"

[12.7mm] hex head bolt and #4 washer in each hole. Be sure

to use threadlocking cement on each bolt.

❏

7. Slide the axles through the landing gear brace as

shown. Secure each axle with a #8 washer and 3/16" [5mm]

nut. Be sure to use threadlocking cement.

❏

8. Slide the main wheels onto the axles. Secure them in

place by putting a 6-32 set screw in a 5/32" [4mm] wheel

collar and tightening it down as shown. Use threadlocking

cement on the set screw.

Note: It is a good idea to remove the wheels and wheel collars

and grind ﬂ at spots on the axles where the set screws made

marks from being tightened. A rotary tool such as a Dremel

with a cutoff wheel or a metal ﬁ le can be used to make the

ﬂ at spots. Then re-install the wheels onto the axles using the

wheel collars, set screws, and threadlocking compound. Be

sure that the wheels rotate freely. Oil the wheels at the axles

if necessary.