GREAT PLANES Silhouette Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Silhouette. GREAT PLANES Silhouette 16 pages.

❏

5. Trial ﬁ t the remaining two plywood control horns in the

bottom of the ailerons. You may need to use a sharp hobby

knife to open the front of the slot to allow the control horns

to seat against the bottom of the aileron. Use foam-safe thin

CA to glue the control horns in the ailerons.

RADIO INSTALLATION

❏ ❏

1. Install a 12" [304mm] servo extension on each aileron

servo. A piece of electrical tape can be used to secure the

extension to the aileron servo lead. Tie the string from one

of the aileron servo trays to the end of the aileron servo lead

extension. Then use a piece of masking tape to secure the

string out the end of the connector.

❏ ❏

2. From the battery compartment, carefully pull the

aileron lead through the wing and out the opening in the

center of the wing.

❏ ❏

3. Use medium foam-safe CA to glue the aileron servo

in the aileron servo tray.

❏

4. Follow the same procedure to install the second aileron

servo in the other wing half.

❏

5. Use a Y-harness to connect the two aileron servos.

Connect the Y-harness to your receiver. A separate receiver

battery or the ESC can be connected to the receiver to power

the servos for set up.

❏

6. Switch on your transmitter and center the aileron

servo trim.

❏ ❏

7. Install a servo arm that has a hole approximately

5/8" [16mm] from the center. Enlarge the hole with a #55

(3/64") drill bit. Insert the brass quick connector in the hole

and secure it with a nylon keeper.