GREAT PLANES Silhouette Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Silhouette. GREAT PLANES Silhouette 16 pages.

❏ ❏

8. Install the servo arm on the servo. Insert the Z-bend

end of a 3-3/8" [86mm] pushrod in the lower hole in the

aileron control horn. Insert the other end of the pushrod in

the quick connector. Install a 2 x 4mm machine screw in the

quick connector. Center the aileron and tighten the machine

screw on the pushrod. Trim the excess wire 1/4" [6mm] from

the quick connector.

❏

9. Return to step 7 and install the pushrod on the

other aileron.

❏

10. Install the rudder and elevator servos in the servo

cutouts in the aft end of the fuselage.

❏

11. Connect the rudder servo to the receiver and center

the servo arm on the servo. Install the 8-3/16" [208mm]

pushrod in the outer hole of the rudder control horn. Follow

the same method to complete the installation as used for the

ailerons except install the brass quick connector in the hole

7/16" [11mm] from the center of the rudder servo arm.

❏

12. Connect the elevator servo to the receiver and center

the servo arm on the servo. Install the 6-1/4" [159mm] pushrod

in the outer hole of the rudder control horn. Follow the same

method to complete the installation as before except install

the brass quick connector in the hole 1/2" [13mm] from the

center of the rudder servo arm.

INSTALL THE MAIN LANDING GEAR

❏

1. Insert the main landing gear wire in the landing gear slot.

❏

2. Insert the plywood landing gear retainer in the landing gear

slot. The rounded corners are inserted ﬁ rst. If it ﬁ ts loosely, use

a piece of tape (not included) to hold the retainer in position.