DayStar KJ04520BK Manuel d'instructions d'installation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} DayStar KJ04520BK. DayStar KJ04520BK 8 pages. 2007 and up jeep wrangler jk body lift 2 door and 4 door
Imprimer la page
3.
Place Jeep on a level ground. Open the hood and use a Phillips screw driver
to twist the center of the push pin insert to release and remove the six push
pin fasteners (1), release the lower clips (3) and separate the grille from the
Jeep and disconnect the electrical connectors (4).
4. With a 16mm socket loosen the two nuts at each of the front core support
body mounts, Then with a 18mm socket loosen the bolts at the right and left
sides of frame body mounts. NOTICE: DO NOT remove nuts at this time.
NOTICE a 2dr will have 10 mount and a 4 door will have 12 mount loca-
tions.
5.
Place the floor jack under the Jeep tub between the front and rear wheel. Rise
up the jack with the 2x4 jacking block on top of the jack and remove only
one side at a time of the bolt and nuts from the Jeep mounts.
5