DayStar KJ04520BK Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe DayStar KJ04520BK. DayStar KJ04520BK 8 stron. 2007 and up jeep wrangler jk body lift 2 door and 4 door

Drukuj stronę

Place Jeep on a level ground. Open the hood and use a Phillips screw driver

to twist the center of the push pin insert to release and remove the six push

pin fasteners (1), release the lower clips (3) and separate the grille from the

Jeep and disconnect the electrical connectors (4).

4. With a 16mm socket loosen the two nuts at each of the front core support

body mounts, Then with a 18mm socket loosen the bolts at the right and left

sides of frame body mounts. NOTICE: DO NOT remove nuts at this time.

NOTICE a 2dr will have 10 mount and a 4 door will have 12 mount loca-

tions.

Place the floor jack under the Jeep tub between the front and rear wheel. Rise

up the jack with the 2x4 jacking block on top of the jack and remove only

one side at a time of the bolt and nuts from the Jeep mounts.