Automatic LPM200 Manuel d'utilisation et d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Automatic LPM200. Automatic LPM200 16 pages. Stationary roller mill

Imprimer la page

Your roller mill is designed to eliminate complicated adjustments. There are only two (2) major points

of adjustment for any small grain or shelled corn - roller spacing and hopper control gate.

1. HOPPER GATE. Open feed gate gradually until you reach the maximum flow of grain that power

will handle. If it becomes necessary to stop the machine at any time before hopper is empty, be

sure to close the feed door before shutting off power.

2. ROLLER SPACING. This depends upon the type of grain to be rolled. Different grain varies in

size, shape, toughness and moisture content. This is also true of the same kind of grain from

different localities. For this reason, it is impossible for us to tell you how to set the rolls. Do not

over-roll hard or dry grains, as this will cause dusting. Remember, proper adjustment keeps dust

at a minimum, even when rolling the driest grain.

The closest roll setting is preset at the factory and as a rule and should not require additional

adjustment. However, for certain types or conditions of rolling, some "fine tuning" may be required.

IMPORTANT - Check to make sure the roll teeth do not come in contact with each other by turning

the mill by hand after each adjustment.

DETAILS OF SPROCKET AND CHAIN routing on mills

equipped with fast roll chain drive. Never operate mill

with rolls touching each other.

Drive roll --

larger sprocket

When ordering parts for your mill, please state your needs with the following information:

MODEL NO.

LPM-200 x 4

When you order in this way, you can be certain the correct part will be delivered in the shortest time possible.

IMPORTANT: Use only genuine factory replacement parts on your mill. Do not substitute homemade or non-

typical parts. If a bolt is lost or in need of replacement, for your safety and the preservation of your mill, be sure

to use a replacement bolt of the same grade (Usually Grade 5).

Repair parts can be ordered through your nearest dealer. If there is no dealer in your area, call

Automatic Equipment Manufacturing at (402) 385-3051.

Basic Assembly ..........................................................................................7/8

Chain Drive ................................................................................................. 9

Belt Drive ................................................................................................... 10

Auger Base .............................................................................................. 11/12

Hopper Assembly ....................................................................................... 13

Frame ......................................................................................................... 14

405-0525 Rev A

1/32"

Idler roll --

smaller sprocket

Replacement Parts

SERIAL NO.

000000

Parts Index

Page 6 of 16

DETAILS OF ROLLERS on mills when no chain

drive is used. As such, rolls can be meshed.

Rolls set together (meshed position)

Note: Rolls turn at same speed.

PART NO.

101-2467

DESCRIPTION

Shim, 20 Ga

4/5/16