Automatic LPM200 Bedienings- en installatiehandleiding - Pagina 6

Blader online of download pdf Bedienings- en installatiehandleiding voor {categorie_naam} Automatic LPM200. Automatic LPM200 16 pagina's. Stationary roller mill

Your roller mill is designed to eliminate complicated adjustments. There are only two (2) major points
of adjustment for any small grain or shelled corn - roller spacing and hopper control gate.
1. HOPPER GATE. Open feed gate gradually until you reach the maximum flow of grain that power
will handle. If it becomes necessary to stop the machine at any time before hopper is empty, be
sure to close the feed door before shutting off power.
2. ROLLER SPACING. This depends upon the type of grain to be rolled. Different grain varies in
size, shape, toughness and moisture content. This is also true of the same kind of grain from
different localities. For this reason, it is impossible for us to tell you how to set the rolls. Do not
over-roll hard or dry grains, as this will cause dusting. Remember, proper adjustment keeps dust
at a minimum, even when rolling the driest grain.
The closest roll setting is preset at the factory and as a rule and should not require additional
adjustment. However, for certain types or conditions of rolling, some "fine tuning" may be required.
IMPORTANT - Check to make sure the roll teeth do not come in contact with each other by turning
the mill by hand after each adjustment.
DETAILS OF SPROCKET AND CHAIN routing on mills
equipped with fast roll chain drive. Never operate mill
with rolls touching each other.
Drive roll --
larger sprocket
When ordering parts for your mill, please state your needs with the following information:
MODEL NO.
LPM-200 x 4
When you order in this way, you can be certain the correct part will be delivered in the shortest time possible.
IMPORTANT: Use only genuine factory replacement parts on your mill. Do not substitute homemade or non-
typical parts. If a bolt is lost or in need of replacement, for your safety and the preservation of your mill, be sure
to use a replacement bolt of the same grade (Usually Grade 5).
Repair parts can be ordered through your nearest dealer. If there is no dealer in your area, call
Automatic Equipment Manufacturing at (402) 385-3051.
Basic Assembly ..........................................................................................7/8
Chain Drive ................................................................................................. 9
Belt Drive ................................................................................................... 10
Auger Base .............................................................................................. 11/12
Hopper Assembly ....................................................................................... 13
Frame ......................................................................................................... 14
405-0525 Rev A
1/32"
Idler roll --
smaller sprocket
Replacement Parts
SERIAL NO.
000000
Parts Index
Page 6 of 16
DETAILS OF ROLLERS on mills when no chain
drive is used. As such, rolls can be meshed.
Rolls set together (meshed position)
Note: Rolls turn at same speed.
PART NO.
101-2467
DESCRIPTION
Shim, 20 Ga
4/5/16