GreatCo GBI-34 Instructions d'installation et manuel d'utilisation du propriétaire de la maison - Page 9

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation du propriétaire de la maison pour {nom_de_la_catégorie} GreatCo GBI-34. GreatCo GBI-34 10 pages. Gallery electric fireplaces
Également pour GreatCo GBI-34 : Instructions d'installation et manuel d'utilisation du propriétaire de la maison (11 pages), Instructions d'installation et manuel d'utilisation du propriétaire de la maison (11 pages)

Imprimer la page
Problem
Fireplace not responding to remote
commands
Fireplace trips circuit breaker or blows
fuse when turned on
Heater is excessively noisy
Odor coming from heater/blower
Flame effect frozen or stuttering
Heater not outputting heat when
turned on.
LED Lighting not turning on
90245 rev A 9-5-2012

TROUBLESHOOTING

Possible Causes
Switch on fireplace not in
the ON position
Remote control battery
dead or not inserted
Remote is not in range of
fireplace or not aimed
Improper circuit rating
Too many appliances
plugged into the same
Blower assembly is dirty
Defective blower
Normal operation
Defective heater
Defective flame motor
Thermal switch tripped
Heater is defective
Thermostat is cycled off
Lighting may be defective
For more information, you can visit us online at
Http://www.GreatCo.com
Or Call Us At:
1-866-303-4028
Switch must be in the ON position for
properly
Move closer to fireplace and aim remote
correctly
Ensure unit is plugged into a dedicated 15
Unplug other appliances on the same
circuit
Blower replacement or repair necessary
Heater is burning off dust accumulated
during manufacture or non-use periods.
This should only be noticeable for a brief
Heater may require replacement or repair
Turn off unit and unplug for 5 minutes. This
is a safety feature to prevent overheating
Replacement or repair may be required
Repair or replacement may be required.
Solution
remote operation
Insert or check battery for correct
orientation
directly at it.
amp circuit
circuit
Unplug unit and clean blower
period after turning on.
Flame motor repair or replacement
required.
Set thermostat to higher setting
9