Greatneck 80161 Manuel du propriétaire - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Greatneck 80161. Greatneck 80161 18 pages. High speed circular saw

Imprimer la page

MATERIALS YOU CAN CUT

The circular saw is a versatile saw that

allows you to cut many different types of

materials. Some of the materials include:

• Wood products such as lumber,

hardwood, plywood, composition

board and panelling

• Drywall

• Masonite and plastic

NOTE: There are several different types of

blades available. Generally, blades with

carbide-tipped teeth cut better and stay

sharp longer. Tooth count and configuration

are also important. High tooth counts cut

slower and are best suited for making

smooth cuts on thinner materials such as

panelling. Use the correct blade for your

application.

GENERAL CUTTING

Make any adjustments to the saw

before plugging it into the power

source. Adjustments include cutting

depth, bevel cutting angle and rip

guide (if installed).

Clearly mark the workpiece to locate

the position of the cut.

Hold smaller workpiece with a vise.

Clamp larger workpiece to a work

bench or table.

DANGER:

Any workpiece that is

not adequately clamped in place may

come loose and cause serious injury.

Never hold the workpiece in your hand.

Make sure there are no nails, screws,

clamps or foreign materials in the path

of the saw blade.

ASSEMBLY AND OPERATION

With both hands firmly gripping the

saw, and the blade NOT in contact with

the surface to be cut, start the saw by

depressing the lock-off button and then

the trigger switch.

Once the saw has reached full speed,

place the front edge of the sole plate

on the workpiece and gradually bring

the moving blade into contact with the

workpiece at the appropriate location.

NOTE: To align the saw blade with the

cutting mark, use the guide marks on the

front of the sole plate (Fig. 8). Use the 0°

line (1) for right angle cuts. Use the 45°

mark (2) for 45° bevel cuts. This will allow

for the extra material needed for the angle

cut. Always make a test cut on a scrap

workpiece before cutting the new material.

WARNING:

circular saw. Use only enough force to

keep the blade cutting at full speed.

Excessive pressure on the blade will

cause it to slow down and overheat,

resulting in poor cut quality and damage

to the motor.

Do not force the

Fig. 8