GALAGAR GALA TIG 3200 ACDC Manuel d'installation rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} GALAGAR GALA TIG 3200 ACDC. GALAGAR GALA TIG 3200 ACDC 4 pages. For modular equipment

Imprimer la page

Fill the coolant liquid tank to maximum level indicated. Use the specific

cooling liquids, never use anti-freeze, tap water or any other electricity

conductor liquid.

For the system to work correctly, we must empty the air from the circuit.

Connect the flexible purge hose in the cooling water outlet.

(blue connector).

Place an empty container at the free end of the flexible hose, then, after

discharging the air, the coolant liquid will come out.

Switch on the equipment until the coolant liquid is made to come out

through the flexible hose by pressure and immediately afterwards switch it

off.

Remove the flexible purge hose and connect the desired setup (torch / set of cables).

In installations with sets of cables, it is advisable to carry out an

intermediate purge of air at the outlet from the wire feed unit.

If the cooling system has been stopped for a long time, the pump shaft could have blocked due to the action of the liquid.

Remove the side cover from the cooling unit.

With the aid of a screwdriver, manually turn the pump shaft.

Repeat the air discharge process from the installation.

TASK

IMAGE

READY

I 

☐