Dynamite DYN4064 Manuel d'utilisation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dynamite DYN4064. Dynamite DYN4064 20 pages. Passport ultra ac/dc charger cycler

Imprimer la page

Select Voltage

10.8V

1. Selected Discharge Voltage Cutoff

The discharge cutoff voltage value is

predetermined when selecting 1.8V, 5.4V, or

10.8V setting for the corresponding 2V, 6V,

or 12V battery being discharged and is not

selectable during discharge.

Input

System Temp 36°C

2. Input Voltage/System Temperature

Dynamite Ultra AC/DC Charger/Cycler

13.01V

warning information

1. If the battery connection is lost during

operation, the OPEN/STOP error will flash.

Reconnect battery or replace.

2. Low Input Volt: Power input is below

minimum requirements. Increase source

power voltage.

3. Reverse Polarity: Battery polarity reversed

4. Waiting Overheating: Charger temperature

overheated. Lower charge/discharge

current rates and be sure the cooling fan is

unobstructed.

5. After discharging, Ni-MH/END will flash

alternately.

6. When the charge reaches the negative delta

voltage, the Ni-MH/FULL is displayed.

7. When the charge reaches the Timed setting

limit, the Ni-MH/TIME is displayed.

8. When the charge reaches the capacity

setting limit, the Ni-MH/CAPA is displayed,

Ni-MH/CAPA will flash alternately.

9. When the charge reaches the Temperature

setting limit, the Ni-MH/TEMP is displayed.

10. Li-Po/Li-Fe Battery Low Voltage, LOW/VOL

will flash alternately.

11. Cooling fan is not working, FAN/STOP will

flash alternately.

System Err

Return to Repair

12. Charger Breakdown

Current Err

Return to Repair

13. Charger Breakdown