ADENDORFF MAC AFRIC SDRILC-024 Mode d'emploi original - Page 7
Parcourez en ligne ou téléchargez le pdf Mode d'emploi original pour {nom_de_la_catégorie} ADENDORFF MAC AFRIC SDRILC-024. ADENDORFF MAC AFRIC SDRILC-024 11 pages. Cordless brushless rotary hammer
Imprimer la pageModel
Input Voltage (AC)
Charging Current
Input Power Frequency
Applicable Battery Cartridge Voltage (DC)
4.0Ah
Full Charging Time
5.0Ah
6.6Ah
Insulation Grade
Switch Action
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch
trigger actuates properly and returns to the "OFF" position when released.
Do not operate the machine at a low
speed for too long, or the inside machine
may be overheated
To start the tool, simply pull switch trigger.
Tool speed is increased by increasing pressure
on the switch trigger and further pressure
results in an increase in speed. Release the
switch trigger to switch off the tool. (Fig. 5)
Reversing Switch Action
CAUTION:
Always check the direction of rotation before operation.
Use the reversing switch lever only after the tool comes to a complete stop. Changing
the direction of rotation before the tool stops may damage the tool. When not operating
the tool, always set the reversing switch lever to the neutral position
Never force to pull the switch trigger while the the reversing switch lever is set to the
center position.
FFCL18-01
SCHARG-001
FFCL18-05
FFCL18-03
(FFCL18-04)
220-240V
110-240V
220-240V
3.0A
2.0A
50-60Hz
18V
≈90min
≈135min
≈100min
≈150min
≈140min
≈210min
Double Insulation
Clockwise Rotation
Depress the reversing switch lever from side B
to side A for clockwise rotation. (view
forwards).
Counterclockwise Rotation
Depress the reversing switch lever from side A
to side B for counterclockwise rotation. (Fig 6)
When set the reversing switch lever to the
neutral position, the button is locked, and
cannot be pressed
Installing or Removing Drill Bit
Apply a small amount of bit grease on the drill bit shank head beforehand, about 0.5-1 g, to
ensure smooth action of the chuck and prolong its service life.
CAUTION:
Before operation, always set the reversing
switch lever in the central position and
remove the battery. Mustn't press switch
trigger.
Clean the bit shank and apply bit grease
before installing the bit. Insert the bit into the
tool. Turn the bit and push it in until it
engages. (Fig. 7)
Demount the drill bit if it cannot be pushed
into. Pull down the locking sleeve several
times, and insert into the drill bit again. Turn
the bit and push it in until it engages.
Pull the drill bit to check that it is locked
correctly.
To remove the bit, push back the locking
sleeve and remove the bit (Fig. 8)