909 305DB Manuel d'instruction - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 305DB. 909 305DB 20 pages. 2000w 255mm (10") single bevel laser guided slide mitre saw

Imprimer la page

Setting the fence square with the table

1. Make sure that the electrical plug is removed from the

power point.

2. Push the saw arm (4) down to its lowest position and

engage the release knob (6) to hold the saw arm in the

transport position.

3. Loosen the mitre lock (24).

4. Rotate the table (20) until the pointer is positioned at 0º.

5. Tighten the mitre lock (24).

7. Using the 6mm hex key provided, loosen the four screws

securing the fence (18) to the base (Fig. c).

8. Place a square against the fence (18) and alongside the

blade (Fig. d).

9. Adjust the fence (18) until it is square with the blade.

10. Tighten the screws securing the fence (18).

11. Loosen the Phillips head

screw holding the pointer

of the mitre scale (21)

and adjust it so that it

accurately indicates the

zero position on the mitre

scale (Fig. e).

12. Retighten the screw

securing the mitre

scale pointer.

13. Replace the top section of the fence and secure the

hex screw using the 6mm hex key.

Changing a blade

DANGER!

Never try to use a blade larger than the stated

capacity of the saw. It might come into contact with the

blade guards. Never use a blade that is too thick to allow the

outer blade washer to engage with the flats on the spindle.

It will prevent the blade screw from properly securing the

blade on the spindle. Do not use the saw to cut metal or

masonry. Ensure that any

spacers and spindle rings

that may be required suit the

spindle and the blade fitted.

1. Make sure that the electrical

plug is removed from the

power point.

2. Push down on the operating

handle (6) and pull the

release knob (5) to

disengage the saw arm (4).

The release knob (5) can

be turned so that it is held in

the retracted position (Fig. f).

3. Raise the saw arm (4) to

its highest position.

4. Using a Phillips head

screwdriver loosen

and remove the screw

that secures the guard

retraction arm (12) to the

rotating blade guard

(Fig. g).

5. Using a Phillips head

screwdriver loosen and

remove the screw that

secures the blade bolt

cover (13) (Fig. h).

6. Pull the rotating blade guard (11) down then swing it up

together with the blade bolt cover (13). When the rotating

blade guard (11) is positioned over the upper fixed blade