909 BN210 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 BN210. 909 BN210 16 pages. 1400w 210mm (8 1/4") compound mitre saw

Imprimer la page

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

1. Remove all loose parts from

the carton.

2. Remove the packing

materials from around

the saw.

3. Using the operating handle

(3) carefully lift the saw from

the carton and place it on a

level work surface.

4. The saw has been shipped

with the saw arm locked

in the down position. To

release the saw arm, push

down on the top of the saw

arm, pull on the release

knob (2) (Fig. A1), rotate it

45° and let go (Fig. A2),

slowly raise the saw arm.

WARNING.

Do not lift the saw whilst holding on to the

guards. Use the operating handle (3).

Transportation

Lift the mitre saw only when the saw arm is locked in the

down position, the saw is switched off and the plug is

removed from the power point.

Only lift the saw by the operating handle (3) or outer

castings. Do not lift the saw using the guards.

Bench mounting

The saw base has holes in

each corner to facilitate bench

mounting (Fig. B).

1. Place the saw on a level,

horizontal bench or work

table using bolts (not

supplied) and fix the saw

to the bench using 4 bolts.

2. If desired, you can mount the saw to a piece of

13mm or thicker plywood which can then be clamped

to your work support or moved to other job sites

and re-clamped.

CAUTION.

Make sure that the mounting surface is not

warped as an uneven surface can cause binding and

inaccurate sawing.

Release knob

The release knob (2) is

provided for holding the

cutting head down whilst

transporting or storing the

mitre saw (Fig. C). The

saw must never be used

with the release knob

locking the head down.