909 BN210 Manual de instruções - Página 9
Procurar online ou descarregar pdf Manual de instruções para Serra 909 BN210. 909 BN210 16 páginas. 1400w 210mm (8 1/4") compound mitre saw
Imprimir página
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from
the carton.
2. Remove the packing
materials from around
the saw.
3. Using the operating handle
(3) carefully lift the saw from
the carton and place it on a
level work surface.
4. The saw has been shipped
with the saw arm locked
in the down position. To
release the saw arm, push
down on the top of the saw
arm, pull on the release
knob (2) (Fig. A1), rotate it
45° and let go (Fig. A2),
slowly raise the saw arm.
WARNING.
Do not lift the saw whilst holding on to the
guards. Use the operating handle (3).
Transportation
Lift the mitre saw only when the saw arm is locked in the
down position, the saw is switched off and the plug is
removed from the power point.
Only lift the saw by the operating handle (3) or outer
castings. Do not lift the saw using the guards.
A1
Bench mounting
The saw base has holes in
each corner to facilitate bench
mounting (Fig. B).
1. Place the saw on a level,
horizontal bench or work
table using bolts (not
supplied) and fix the saw
to the bench using 4 bolts.
2. If desired, you can mount the saw to a piece of
13mm or thicker plywood which can then be clamped
to your work support or moved to other job sites
and re-clamped.
CAUTION.
Make sure that the mounting surface is not
warped as an uneven surface can cause binding and
inaccurate sawing.
Release knob
The release knob (2) is
provided for holding the
cutting head down whilst
transporting or storing the
mitre saw (Fig. C). The
saw must never be used
with the release knob
locking the head down.
9
B
C