909 BN210 Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Serra 909 BN210. 909 BN210 16 páginas. 1400w 210mm (8 1/4") compound mitre saw

Imprimir página

Setting the fence square with the table

1. Make sure that the electrical plug is removed from the

power point.

2. Push the saw arm (1) down

to its lowest position and

engage the release knob (2)

to hold the saw arm in the

transport position.

3. Loosen the mitre locks (15).

4. Rotate the table (12) until

the pointer is positioned

at 0º.

5. Tighten the mitre locks (15).

6. Using a 5mm hex key,

loosen the two screws

securing the fence (11) to

the base (Fig. N).

7. Place a square against the

fence (11) and alongside

the blade (Fig. O).

8. Adjust the fence (11) until it

is square with the blade.

9. Tighten the screws

securing the fence (11).

10. Loosen the Phillips head

screw holding the pointer

of the mitre scale (13)

and adjust it so that it

accurately indicates the

zero position on the mitre

scale (Fig. P).

11. Retighten the screw securing the mitre scale pointer.

Changing a blade

DANGER!

Never try to use a blade larger than the stated

capacity of the saw. It might come into contact with the

blade guards. Never use a blade that is too thick to allow the

outer blade washer to engage with the flats on the spindle.

90º

It will prevent the blade screw from properly securing the

blade on the spindle. Do not use the saw to cut metal or

masonry. Ensure that any spacers and spindle rings that

may be required suit the spindle and the blade fitted.

1. Make sure that the electrical plug is removed from the

power point.

2. Push down on the operating handle (3) and pull the

release knob (2) to disengage the saw arm (1).

3. Raise the saw arm (1) to its highest position.

4. Using a Phillips head screwdriver loosen and remove the

Phillips head screw that secures the guard retraction arm

(6) to the rotating blade guard (5) (Fig. Q1 -Q2).

5. Using a Phillips head screwdriver loosen the Phillips head

screw that secures the blade bolt cover (19) (Fig. R).

6. Pull the rotating blade guard (5) down then swing it up

together with the blade bolt cover (19). When the rotating

blade guard (5) is positioned over the upper fixed blade

guard (4) it is possible to access the blade bolt (Fig. S).