Hifonics BOLTAR 2K Manuel rapide - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Hifonics BOLTAR 2K. Hifonics BOLTAR 2K 12 pages. Mt olympus
Imprimer la page
MULTI-AMPLIFIER APPLICATIONS
Front/Rear high pass, using a 2 channel amplifier for mono sub bass
The combination of a BOLTAR or COLOSSUS PRO and a JUPITER
amplifier, utilizing their built in crossovers, makes it a snap to put together a
full system with front and rear highs, with mono sub bass.
Interconnect cable checklist:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
the inputs of the 4 channel JUPITER as shown.
- Also connect the LINE OUT of the JUPITER to the LINE INPUT of the 2
channel COLOSSUS PRO amplifier as shown.
Mono bass woofer wiring:
Connect the mono speaker positive terminal to the LEFT +, and its negative
terminal to RIGHT -.
Switch setting checklist:
4 channel highs amplifier:
- 1/2CH X-OVER: HP
- PARAMETRIC EQ FREQUENCY: X10
- CROSSOVER FREQUENCY: X10
- 3/4CH X-OVER: HP
- PARAMETRIC EQ FREQUENCY: X10
- CROSSOVER FREQUENCY: X10
STEREO
INTERCONNECT
RCA CABLE
2 channel bass amplifier(COLOSSUS PRO is used in the example below):
- X-OVER switch: LP/BP
- PARAMETRIC EQ FREQUENCY: X1
- CROSSOVER FREQUENCY: X1
Please note that these frequency points are suggestions only. Refer to the
loudspeaker manufacturer specifications and the section "Setting up systems
after installation for best performance"
Level control checklist:
- Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedances:
TITAN:
- 2-Ohm per channel in stereo mode.
- 4-Ohms mono bridged.
COLOSSUS PRO:
- 1-Ohm per channel in stereo mode.
- 2-Ohms mono bridged.
JUPITER:
- 2-Ohms per channel in stereo mode.
- 4-Ohms mono bridged.
MONO SPEAKER
or SUBWOOFER
REMOTE TURN-ON
DUAL CHASSIS GROUND
DUAL BATTERY +12v
VIA FUSE