909 LT18V Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 LT18V. 909 LT18V 20 pages. 20v lithium ion cordless line trimmer
Imprimer la pageAssembly
Assembly of the lower guard is required prior to operation.
Prior to carrying out any assembly work, adjustments or
maintenance, ensure the battery pack has been removed
from the rear of the housing so operation of the trimmer is
impossible.
Guard assembly
1. Fit the guard on to the previously fitted trim by placing the
guard over the spool and line and allow the guard to sit
on the underside of the motor housing. Ensure that both
lines have passed through the hole in the guard and are
not trapped under the guard.
4. Secure the guard using the 3 screws through the guard
into the housing. Ensure the screws are tight.
Wire plant protector
To fit the protector, insert the tails of the protector into
the holes located on each side of the motor housing.
The protector will lift vertically when not in use.
Adjusting the telescopic handle.
The distance between the top handle and the cutting head
can be adjusted to suit the comfort of the operator.
1. To adjust the length, loosen the shaft adjustment lock,
and then extend or shorten the length of the shaft.
2. When the desired length of shaft is achieved, tighten the
shaft adjustment lock to lock the shaft to the selected
length.
11