909 52371 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 909 52371. 909 52371 18 pages. 140cc 4 stroke petrol

Imprimer la page

Assembly

WARNING: Stop the engine and unplug the spark plug before any

repairs or maintenance operations.

WARNING: DO NOT attempt to start this mower without first adding

0.6L of SAE 10W-30 engine oil to the Engine. Refer to the oil chart on

page 16 to confirm the correct oil for various conditions.

WARNING: Do Not attempt to start this mower without the mower

first being FULLY assembled.

It is necessary to fit the lower handles (6), upper handle and bar (1),

and the 60L hard catcher (7) to the mower before use.

Attaching the Lower Handles

NOTE: When preparing for this assembly, slowly and carefully raise the

handles without pulling or putting any strain on the cable. Ensure the cable

is not tangled or crossing over.

1. Remove the lower handle locking knobs (8) from the lower handle

mounting plates (10). (Fig A)

2. Position each of the lower handles (6) on the inside of the lower handle

mounting plate (10), and locate the circle hole on each end of the lower

handles (6) onto the large locating pins (one each side) on the lower

handle mounting plates (10) on each side. (Fig B)

3. This mower has a 3 height adjustment for the positioning of the handles,

with the lowest notch positioning the handle bars closer to the ground,

and the highest notch raising the handle bars up towards the user. (Fig C)

e-mail: [email protected]

MODEL: №. 52371

140cc 4 Stroke Petrol Lawn Mower

AFTER SALES SUPPORT

1800 909 909

(toll free)

140cc 4 Stroke Petrol Lawn Mower

4. Once you have decided the positioning of the

handles to suit your mowing height, locate the

square hole up from the bottom of the lower

handles (6), and position so they match the

square notch on the lower handle mounting

plates (10). (Fig D)

5. Insert the screw through the lower handle

square hole, then through the mounting plate

(10), and secure into position by then screwing

the lower handle locking knob (8) onto the

screw on the external side of the lower handle

mounting plate (10). (Fig E)

6. Secure the lower handle locking knob (8)

until finger tight.

7. Repeat on the opposite side ensuring both of

the handle locking knobs are firm and secure.

Attaching the Upper Handles

With the lower handles in position, the upper

handles and bar (1) can now be secured

in position.

1. When the upper handles (1) are in line with

the lower handles (6) secure them in position

by pulling the upper handle locking lever (5)

towards the upper handle bar (1) and locking

the handle in position (repeat other side). (Fig F)

NOTE: Tension on the upper handle locking

levers can be adjusted by rotating the lever

knob.

AFTER SALES SUPPORT

1800 909 909

(toll free)

e-mail: [email protected]

MODEL: №. 52371