909 TBD15009 Manuel d'instruction - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 TBD15009. 909 TBD15009 14 pages. 1/2 hp benchtop belt/disc sander

Imprimer la page
Sanding small end surfaces
on the sanding disc
1. Use of the mitre gauge
is recommended for this
operation.
2. Rest the workpiece against the
edge of the mitre gauge.
3. Always move the work across
the left hand side of the
sanding disc.
4. The table may be tilted for bevelled work.

Maintenance

Note: Always wear eye protection when cleaning the tool.
WARNING:
Always ensure that the sander is switched off
and unplugged from the power supply before carrying out
any maintenance or cleaning.
1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION:
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool.

Power cord maintenance

If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.

General inspection

Regularly check that all the fixing screws are tight.
They may vibrate loose over time.

Repairs

Only an authorised service centre should replace the
cordset or carry out other repairs.
Once a month, lubricate all moving parts with machine
oil. Take care to keep the oil away from any electrical
components.
Parts should only be replaced or repaired by an authorised
service centre.
13