- ページ 13

サンダー 909 TBD15009のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。909 TBD15009 14 ページ。 1/2 hp benchtop belt/disc sander

Sanding small end surfaces

on the sanding disc

1. Use of the mitre gauge

is recommended for this

operation.

2. Rest the workpiece against the

edge of the mitre gauge.

3. Always move the work across

the left hand side of the

sanding disc.

4. The table may be tilted for bevelled work.

Note: Always wear eye protection when cleaning the tool.

WARNING:

Always ensure that the sander is switched off

and unplugged from the power supply before carrying out

any maintenance or cleaning.

1. Keep the tool's air vents unclogged and clean at all times.

2. Remove dust and dirt regularly. Cleaning is best done

with a brush or a rag.

3. Re-lubricate all moving parts at regular intervals.

4. Never use caustic agents to clean plastic parts.

CAUTION:

Do not use cleaning agents to clean the plastic

parts of the tool. A mild detergent on a damp cloth is

recommended. Water must never come into contact with

the tool.

If the supply cord needs replacing, the task must be carried

out by the manufacturer, the manufacturer's agent, or an

authorised service centre in order to avoid a safety hazard.

Regularly check that all the fixing screws are tight.

They may vibrate loose over time.

Only an authorised service centre should replace the

cordset or carry out other repairs.

Once a month, lubricate all moving parts with machine

oil. Take care to keep the oil away from any electrical

components.

Parts should only be replaced or repaired by an authorised

service centre.