DynaQuip Controls WaterCop classic Manuel du propriétaire et manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et manuel d'installation pour {nom_de_la_catégorie} DynaQuip Controls WaterCop classic. DynaQuip Controls WaterCop classic 12 pages.

Imprimer la page

Additional Components Available for Your WaterCop

Single and Dual Probe WaterCop
WCDFS1 (single probe) and WCDFS2 (dual probe)
•
Battery or AC (optional) powered
•
Transmits wireless signal to valve when moisture
is detected
•
Unlimited number can be used, placed anywhere
•
10' sensor cord, white

Low Temperature Sensor

WCDFST
•
Monitors temperature of pipes prone to freezing
•
Sends wireless signal to turn off water if low
temperature detected
•
10' cord with clip to attach to pipe
•
Flood sensor with probe

Installation Guide

IMPORTANT!
Adherence to all local and municipal building, plumbing and electrical codes as they pertain to the installation of the
WaterCop
CLASSIC System is of utmost importance . Codes in some areas may require that a licensed plumber be
®
employed to do the installation, or that the proper permits be obtained prior to any installation . Even if local codes do not
require a licensed plumber to do the installation, it is necessary that the installer has a professional level of competence
in both plumbing and electrical skills to perform the installation . These instructions assume this level of knowledge and
skill . If in doubt, use a licensed professional .

Pre-Installation Testing of WaterCop

Although each unit is pre-tested at the factory, it is highly recommended that the unit be tested prior to installation to
ensure proper operation in your home . Operating the valve before connecting to the water line will not damage it .
Use caution!
CAUTION!
•
The valve closes with great force. It could cut off a finger.
•
Keep fingers and other items out of the valve when testing.
STOP
WARNING!
installed where it could ignite flammable vapors or explosive mixtures.
WARNING!
Do not use extension cords. Use of extension cords can cause fires or electric shock. Install
STOP
WaterCop
all local codes.
DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077
Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com
Flood Sensors
®
The WaterCop
case is NOT EXPLOSION PROOF. The shut-off valve must NOT be
®
To reduce risk of electrical shock, fire, or damage to property or WaterCop
within 20 feet of an outlet or, install an outlet near the WaterCop
®
®

Water Control Wall Switch

RS100
•
Proactively turn water on or off from convenient location
•
Lighted display to valve position (on or off)
•
Requires category 5E cabling connection to valve
(see Wall Switch Interconnect Cable below)

AC Power Adaptor

•
For WCDFS1, WCDFS2, and WCDFST sensors
•
Eliminates the need for AA batteries
WaterCop
/ Wall Switch Interconnect Cable
®
CBL50 (50 feet) and CBL100 (100 feet)
•
Required to connect WaterCop
Control Wall Switch
•
RJ45 molded connections for easy installation and
durability
®

CLASSIC System

valve with Water
®
:
®
. Comply with
®
7