DynaQuip Controls WaterCop classic Manuel du propriétaire et manuel d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et manuel d'installation pour {nom_de_la_catégorie} DynaQuip Controls WaterCop classic. DynaQuip Controls WaterCop classic 12 pages.

Imprimer la page

The red indicator light will signal that the valve is now in the closed position, and that you

need to check all areas where you have placed a sensor to determine what plumbing

product caused the system to activate .

The valve will remain closed until the unit is manually reset on the WaterCop

the plumbing problem is fixed, reset the WaterCop

the face of the WaterCop

at right .

Note: If major repairs are needed to correct the plumbing system, it is recommended that

the manual shut-off valve upstream of the WaterCop

Close the main water shut-off valve and unplug the WaterCop

the plumbing system .

Note: In case of a power failure, the WaterCop

will need to use the manual shut-off valve to turn the water off in case of an emergency . When power is restored, the

WaterCop

will remain in its last known position indicated by the red or green lights on the face of the unit .

WaterCop

Actuator

Max . working pressure

Ambient temperature

Enclosure

Voltage

Current

Accessories

Sensor Signal Repeater

Sensors

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiver;

•

Increase the separation between the equipment and receiver;

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;

•

Consult the dealer for help .

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation of the device .

Caution:

The user is cautioned that changes and modification made to the equipment without the approval

of the manufacturer could void the user's authority to operate this equipment.

DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077

Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com

. Valve will open and green indicator will be lit . See illustration

Specifications

125 PSIG

35° to 105° F

Polycarbonate

12 VDC includes 120 VAC adaptor

0 . 8 5 AMPS (Full Load)

120 VAC 47mA

3 VDC (2AA Batteries) 10mA

by pressing "OPEN" (green circle) on

also be closed during the repairs .

before making repairs on

cannot operate . If the power is out, you

Valve

Valve Seals

Flow Data

Valve Size Cv = Gpm flow @ 1 PSI pressure drop

1/2" NPT

3/4" NPT

1" NPT

1-1/4" NPT

For cold water applications

panel . After

Full-Port, Lead-Free Brass, NPT

RTFE (Reinforced Teflon)