activTek AP3000 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} activTek AP3000. activTek AP3000 12 pages. Portable whole home office system
Également pour activTek AP3000 : Manuel (16 pages), Manuel de l'utilisateur (12 pages)

Imprimer la page

OPERATION

1 . Adjust the fan speed to your preference, keeping in

mind that higher fan speeds will give better results .

2 . Using the Normal/High button, set the unit to

NORMAL, for typical use, or HIGH, for increased smoke

and odor control .

3 . For HIGH MODE, using the PURIFIER UP and PURIFIER

DOWN buttons on the remote control, adjust the

purification level to its lowest setting (250ft

the first 24 hours of operation, then gradually adjust up

(if needed) to the square footage (or square meters) of

the indoor area .

If you are operating your central heating and

air conditioning fan, or other ventilation system,

continuously, set the coverage up to the total

ventilated indoor area. Otherwise, set the coverage up

to the size of the room. Do not exceed the size of the

ventilated indoor area when setting the purifier level.

Fan Speed

Purifier Setting

HIGH MODE: The unit's display shows the fan speed

(low to high), the purifier setting (1 bar to 12 bars), and

the purifier coverage in square feet, for U.S. models, and

square meters, for international units.

PLACEMENT OF UNIT

(23 m

)) for

Purifier Coverage

Place the unit as high as possible to ensure

complete purification (On top of a bookshelf,

high cabinet, etc .) .

Suggested locations listed in the order of

preference:

1 . Nearest the source of the worst pollution .

2 . Near a cold-air return to thoroughly circulate

the benefits of your AP3000 by activTek

throughout the area .

3 . In the area most heavily used to achieve

maximum benefit .

4 . To operate the AWAY MODE feature, in unoccupied

areas only,* press the Away Mode button on remote

control until the desired time is reached (2, 4, 6, or

8 hours) . The unit will display AWAY MODE and the

remaining time . To interrupt the AWAY MODE, press

the Normal/High button .

*Please note: "unoccupied areas" includes pets. Some

pets, like humans, may experience adverse reactions

from exposure to increased levels of ozone and should

not be present during AWAY MODE operation.

Fan Speed

ActivePure (RCI) cell and Ionization

NORMAL MODE: The unit's display shows the fan speed (low

to high) and NORMAL to indicate that the ActivePure (RCI)

cell and ionization are both functioning normally.

Fan Speed (Max)

Time Remaining

AWAY MODE: The fan will show maximum, and AWAY

MODE will replace the purifier setting. The amount of

time remaining will depend on how long you have selected

for the AWAY MODE function to operate. The colon (:) will

flash to indicate time being counted down.

Note:

• The rear of the unit should always

have at least one inch of open

area to allow unrestricted airflow .

• Point the unit toward the center of

the room for maximum dispersion

of ions .

• To prevent injury, be sure the

power cord is not accessible to

small children .

Away Mode