Autool BT160 Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Autool BT160. Autool BT160 10 pages. Automotive electric system tester
Imprimer la page
★ When component's control switch is located the at side of
negative terminal of component , press button to "=" side to have
LED light GREEN. Contact probe tip to the negative terminal of
component. The component will be activated.
★ When it comes to check each little metal points in
lamp's socket , connect auxiliary ground lead to ground of
component. Then press button to "-" side to have LED light RED.
Contact probe tip to each metal points individually. The
component will be activated.
★ If color of LED changes along with buzzer sounding, stop
testing and check the component if defective or not, or rating
current of component is higher than that of this tester.
NOTE: DO NOT operate it in area with combustible gas,
dust and explosive conditions. NOT allowed to use it with AC
and over 24V DC circuit.
6.Jumper Lead Operation
The black clip and auxiliary ground lead are connected
directly through the unit. User can consider it as a long jumper
test lead by leave the red clip disconnected from the battery.
+ -
马达
motor