Autool BT160 사용자 설명서 - 페이지 7

{카테고리_이름} Autool BT160에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool BT160 10 페이지. Automotive electric system tester

★ When component's control switch is located the at side of

negative terminal of component , press button to "=" side to have

LED light GREEN. Contact probe tip to the negative terminal of

component. The component will be activated.

★ When it comes to check each little metal points in

lamp's socket , connect auxiliary ground lead to ground of

component. Then press button to "-" side to have LED light RED.

Contact probe tip to each metal points individually. The

component will be activated.

★ If color of LED changes along with buzzer sounding, stop

testing and check the component if defective or not, or rating

current of component is higher than that of this tester.

NOTE: DO NOT operate it in area with combustible gas,

dust and explosive conditions. NOT allowed to use it with AC

and over 24V DC circuit.

6.Jumper Lead Operation

The black clip and auxiliary ground lead are connected

directly through the unit. User can consider it as a long jumper

test lead by leave the red clip disconnected from the battery.

+ -

马达

motor