Autool CT400 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Autool CT400. Autool CT400 14 pages. Injector cleaner & tester
Imprimer la page
time. (The system defaults to 10 minutes, if you need to modify the time, you can
change it with the up and down keys)
● Press the run key, and the system starts to input pulse signals.
When finished cleaning, take out the injectors from the ultrasonic tank. Wipe off
the cleaning liquid with a soft cloth and prepare for the next operation.
Notes:
● During the cleaning process, you can hear the intermittent vibration when
you take the fuel injector out and put it near your ear, which can determine
whether the injector has a pulse signal.
● Before the injector detergent is added into the ultrasonic cleaner, do not turn
on the ultrasonic cleaner. Otherwise, damage may be incurred.
● Only the ultrasonic cleaning liquid matched with the machine can be added
to the ultrasonic tank, and other cleaning liquid can not be used instead,
otherwise, the surface coating of the equipment and the mask will peel off, which
will not be covered by the warranty.
3.2 Test functions
This function is to detect the sprayability, dripping, blockage, fuel injecting
angle of the fuel injectors and the amount and uniformity of the fuel injection of
each fuel injector at different RPM.
3.2.1 Preparation
● Add test liquid. Pour the test liquid from the filling port. (Approximately
1000ML is added, and the liquid level should not be lower than 800ML every
time)
● Installation of fuel injectors
Schematic diagram of injector installation
A. Install the injector adapter and the plug into the Fuel distributor assembly
B. Install the fuel injector in the forward direction (apply a little grease on the "O"
ring of the fuel injector)
Fuel distributor
assembly
Adapter for fuel
injector
Injector
5