Autool CT400 사용자 설명서 - 페이지 8

{카테고리_이름} Autool CT400에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT400 14 페이지. Injector cleaner & tester

time. (The system defaults to 10 minutes, if you need to modify the time, you can

change it with the up and down keys)

● Press the run key, and the system starts to input pulse signals.

When finished cleaning, take out the injectors from the ultrasonic tank. Wipe off

the cleaning liquid with a soft cloth and prepare for the next operation.

Notes:

● During the cleaning process, you can hear the intermittent vibration when

you take the fuel injector out and put it near your ear, which can determine

whether the injector has a pulse signal.

● Before the injector detergent is added into the ultrasonic cleaner, do not turn

on the ultrasonic cleaner. Otherwise, damage may be incurred.

● Only the ultrasonic cleaning liquid matched with the machine can be added

to the ultrasonic tank, and other cleaning liquid can not be used instead,

otherwise, the surface coating of the equipment and the mask will peel off, which

will not be covered by the warranty.

3.2 Test functions

This function is to detect the sprayability, dripping, blockage, fuel injecting

angle of the fuel injectors and the amount and uniformity of the fuel injection of

each fuel injector at different RPM.

3.2.1 Preparation

● Add test liquid. Pour the test liquid from the filling port. (Approximately

1000ML is added, and the liquid level should not be lower than 800ML every

time)

● Installation of fuel injectors

Schematic diagram of injector installation

A. Install the injector adapter and the plug into the Fuel distributor assembly

B. Install the fuel injector in the forward direction (apply a little grease on the "O"

ring of the fuel injector)

Fuel distributor

assembly

Adapter for fuel

injector

Injector