Autopage RF-700 Manuel d'utilisation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Autopage RF-700. Autopage RF-700 20 pages. Vehicle security system
9. CHANGING THE REMOTE
TRANSMITTER BATTERY
The RF-700 remote transmitter uses one (1) 12
volt miniature battery, #EL12, #VR22, or
Radio Shack #23-144. It will provide
approximately six months of operation before
replacement is necessary.
To replace the battery, carefully remove the
case screw located at the end of the remote
transmitter where the key ring attaches to its
case. Use a small blade Phillips screwdriver.
Before removing the battery note the direction
of its terminals. Install the new battery exactly
the same, using caution so as not to bend, or
otherwise damage the battery contacts.
Replace the case cover and carefully tighten the
B. VALET/OVERRIDE SWITCH
NOTE: Both VALET and OVERRIDE functions are performed from the same switch.
1. OVERRIDE FUNCTION
The OVERRIDE FUNCTION may be used if the RF-700 remote is lost or inoperative. To operate
the OVERRIDE FUNCTION, enter the vehicle (alarm will sound). Switch the ignition to ON. Push
the momentary VALET/OVERRIDE switch. The alarm will stop. The RF-700 will be disarmed.
Quickly replace or service the remote transmitter to insure continued vehicle protection.
2. VALET FUNCTION (TEMPORARY)
To engage temporary valet alarm must be disarmed and the ignition off. Press both arm and disarm
buttons on the transmitter at the same time. The RF-700 will respond with three confirming chirps.
The RF-700 may be placed into temporary valet mode when valet parking the vehicle. Temporary
valet mode will allow the vehicle to be driven without giving the valet operator the RF-700 transmitter.
screw. Do not over-tighten the screw. Test the
transmitter to be sure it arms and disarms the
alarm.
NOTE:
difficulity be experienced
after changing the battery.
reopen the transmitter
and push the reset switch
located above negative
battery terminal.
+
10
Should any
Reset switch
-