Autopage RF-700 Operation Instructions Manual - Page 10

Browse online or download pdf Operation Instructions Manual for Car Alarm Autopage RF-700. Autopage RF-700 20 pages. Vehicle security system

Print Page

9. CHANGING THE REMOTE

TRANSMITTER BATTERY

The RF-700 remote transmitter uses one (1) 12

volt miniature battery, #EL12, #VR22, or

Radio Shack #23-144. It will provide

approximately six months of operation before

replacement is necessary.

To replace the battery, carefully remove the

case screw located at the end of the remote

transmitter where the key ring attaches to its

case. Use a small blade Phillips screwdriver.

Before removing the battery note the direction

of its terminals. Install the new battery exactly

the same, using caution so as not to bend, or

otherwise damage the battery contacts.

Replace the case cover and carefully tighten the

B. VALET/OVERRIDE SWITCH

NOTE: Both VALET and OVERRIDE functions are performed from the same switch.

The OVERRIDE FUNCTION may be used if the RF-700 remote is lost or inoperative. To operate

the OVERRIDE FUNCTION, enter the vehicle (alarm will sound). Switch the ignition to ON. Push

the momentary VALET/OVERRIDE switch. The alarm will stop. The RF-700 will be disarmed.

Quickly replace or service the remote transmitter to insure continued vehicle protection.

2. VALET FUNCTION (TEMPORARY)

To engage temporary valet alarm must be disarmed and the ignition off. Press both arm and disarm

buttons on the transmitter at the same time. The RF-700 will respond with three confirming chirps.

The RF-700 may be placed into temporary valet mode when valet parking the vehicle. Temporary

valet mode will allow the vehicle to be driven without giving the valet operator the RF-700 transmitter.

screw. Do not over-tighten the screw. Test the

transmitter to be sure it arms and disarms the

alarm.

NOTE:

difficulity be experienced

after changing the battery.

reopen the transmitter

and push the reset switch

located above negative

battery terminal.

Should any

Reset switch