Autopage RF-320 Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Autopage RF-320. Autopage RF-320 12 pages. Professional vehicle security system

Imprimer la page

Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape

wires that pass through holes on the firewall to prevent fraying. Be careful of sharp edges

that may damage wires and causes short circuit.

CAUTION:

Do not connect the wire harness to the control module until all wiring to

vehicle is complete.

H1: MAIN 5 PIN WIRE HARNESS:

H1/1. RED / WHITE WIRE – PARKING LIGHT RELAY INPUT --

The RED/WHITE wire is the input to the flashing parking light relay. The connection of

the RED/WHITE wire will determine the output polarity of the flashing parking light relay.

If the vehicle you are working on has +12volt switched parking lights, you don't need to

connect this wire. This wire is already connected to +12volt.

If the vehicle's parking lights are ground switched, cut the RED/WHITE wire, and

connect the wire to chassis ground.

H1/2. WHITE WIRE -- PARKING LIGHT RELAY OUTPUT (+12V 15A OUTPUT) --

Connect the WHITE wire to the parking light wire coming from the headlight switch. Do

not connect the white wire to the dashboard lighting dimmer switch. (Damage to the

dimmer will result). The limitation of the white wire is 10 AMP max. Do not exceed this

limit or damage to the alarm and parking relay will result.

H1/3. BLACK WIRE -- SYSTEM GROUND –

This is the main ground connection of the alarm module. Make this connection to a solid

section of the vehicle frame. Do not connect this wire to any existing ground wires

supplied by the factory wire loom. Make the connection to the vehicle's frame directly.

H1/4. BROWN WIRE – (+) SIREN OUTPUT –

This is the positive (+) output connection for the siren. Current capacity is 2 amps.

Make connection to the (+) red wire from the siren. Connect the (-) black wire coming

from the siren to a good chassis ground.

H1/5. RED WIRE -- SYSTEM POWER (+12V CONSTANT) --

This wire supplies power to the system. Connect this wire to a constant +12 volt source.

H2: 4 PIN ORANGE CONNECTOR FOR 2 STAGE SHOCK SENSOR

Function: Allows easy positive, negative, instant trigger, and warn-away trigger connection

with quick disconnect ability for other detection devices.

WIRING

4. Green Wire / Warn Away Input

3. Blue Wire / Zone 4 Ground Trigger

2. Black Wire / Negative

1. Red Wire / +12Volts