DCS Rossini Manuel de l'utilisateur - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DCS Rossini. DCS Rossini 17 pages. Digital audio master clock

dCS Rossini Clock User Manual
R
P
EAR
ANEL
D

Label

The label (D) states the unit's serial number and the nominal voltage to which the unit is set. It is
important to quote the serial number if you need assistance.

Word Clock Outputs

The unit features three
• Output
1
(E) generates 44.1kHz.
• Output
2
(F) generates 48kHz.
• Output
3
(G) is set to 44.1kHz at power up, it can be set to either 44.1 or 48kHz by RS232
commands.
Word Clock is used for synchronisation only, it does not carry digital audio data.

RS232 Interface

RS232 interface on 2x 9-way male D-type connectors. The
Loop
controller device, the
The interface is designed to be used with "straight through" cables, wired pin 1 to pin 1, etc.
The pin connections are:
• Pin 2 – dCS unit transmit
• Pin 3 – dCS unit receive
• Pin 5 – ground
• Shell – cable screen & drain wire
When the Clock is looped through to the Rossini Player / DAC, pressing the
Player / DAC sends an RS232 command to set the Clock to Sleep / Wake / Off also. Both units must
be in the same RS232 mode (Binary or Text) – the Clock always powers up in Binary mode.

Mains inlet

Power is connected via a standard IEC320 connector (J), protected by a fuse and isolated by a 2-pole
power switch.
Rossini Clock Manual v1_0x
E
F
G
Figure 4 – Rear panel
Word Clock
Outputs:
connector (I) loops through to the Rossini Player or DAC.
Input
Page 12
Software Issue 1.0x
February 2016
J
H
I
connector (H) is driven from a
Power
button on the
English version